Are your custom made exterior vinyl shutters ready to be installed?
Follow these 5 easy steps and enjoy the beautiful and inviting look of your previously unadorned windows!
Step 1 – Place your exterior vinyl shutter next to the window and mark desired location against the wall or window.
Step 2 – For smaller sizes use four Shutter-Loks per shutter. For large sizes 55″ and over, use six Shutter-Loks per shutter.
Step 3 – To help ensure proper alignment mark or pre-drill holes using a 1/4″ drill bit into the shutter before
Step 4 – With the shutter in location against the wall, drill through the shutter into the wall surface 3 1/4″ deep. Make sure you drill holes deep enough so the Shutter-Lok doesn’t bottom out.
Step 5 – Grasp the Shutter-Lok supporting shank and push it through the shutter hole and into the wall surface. Tap the Shutter-Lok gently with a hammer to snug the shutter against the siding. Do not over tighten , or this will cause the shutter to dimple.
Note: To remove shutters do not attempt to pull out the Shutter-Loks. Simply use a pair of snips and slide them behind the shutter to cut the Shutter-Lok off at the shank. Additional Shutter-Loks can be purchased separately.
Installing exterior vinyl shutters on your home is an affordable way to give your home a new, updated look while increasing its value. EAP Custom and Standard Sizes Exterior Vinyl Shutters are 100% made and assembled in the USA. The absolute best components and Designer Colors that last a virtual lifetime. Call today for a consult!